Author:
• Saturday, November 21st, 2026

At this website you can find a lot of information – and opinion – about hand planes. Here I want to guide new or early woodworkers in building their tool arsenal, and share my ways with veteran woodworkers. 

Here is the plane I started with as I went into more serious woodworking: the #5 jack plane. It is 14” long, has a 45° bed angle with the bevel-down blade. Now with nearly half a century of use, it is still doing the jobs. This is a Record plane, around before Lie-Nielsen or Lee Valley were making planes. I refined it over the years with a Veritas cap iron (chip breaker) ground to a 50° end bevel, a great Hock A2 cryo blade (sharpened 27.5°/32.5°), and wonderful handles made by the masterful Bill Rittner. 

The #5 jack can cover most work. Like any tool, it is not ideal for the full range of related tasks. However, with care, you can cover more than you can with any other plane. You can flatten, straighten, smooth, and fix. For sure, this is the first one to buy for new woodworkers. 

Now for the next three to get. I cannot give you a definitive plan, nor do I think anyone can, but here are my suggestions. Start the crowd with a #1. Yes, a little bench plane! I really like my Veritas bevel-up #1: just under 6” long with a 15° bed. I keep two excellent Veritas PM-V11 blades. 

The #1’s blade is just 1 7/32” wide but can do more and solve more than you might guess. I can grip the original Veritas handles very well and maneuver the plane nicely. It accomplishes tasks that are more awkward with block planes. 

Next comes one of my favorite tools of any kind in the shop: the Lie-Nielsen #4 bronze smoothing plane. It is 9 1/2” long with a 2” wide bevel-down blade on a 50° bed (frog). I use a Veritas PM-V11 (27.5°/32.5°) and a Lie-Nielsen O1 (25°/30°). It is wonderful for smoothing with the blade dead sharp.    

The extra 5° of the bed, along with the carefully prepared and close cap iron (50°, like for the #5), really help, especially with woods more likely to tear. Yes, some wood species can be trouble with any plane, and we can sand and/or hand scrape almost anything, but smoothing with the #4 is a joy! Rittner handles make it even better.

The #7 jointer plane is the definitive straight and flat big man: 22” long, 45° bed for the bevel-down, 9/64” thick, 2 3/8” wide, Lie-Nielsen A2 blade (sharpened 27.5°/32.5°) set under the L-N cap iron set like the #5. 

More than any other plane, success with flattening and straightening edges or faces with the #7 requires good board set up, good body balance, variable and correct hand pressure, and organized planing sequence. Yet, the jobs you can do with it are done like with no other plane. 

But what about other bevel-up (“low angle”) alternatives? They are just as good overall. Since I have and use them too, let’s go over them in the next post.

Category: Tools and Shop
You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.
Leave a Reply