Comments on: Sharpening bench – part 2 https://www.rpwoodwork.com/blog/2013/03/14/sharpening-bench-part-2/ inside the woodshop Tue, 19 Sep 2017 14:24:47 +0000 hourly 1 https://wordpress.org/?v=6.9.4 By: Rob https://www.rpwoodwork.com/blog/2013/03/14/sharpening-bench-part-2/#comment-117981 Mon, 18 Mar 2013 05:47:21 +0000 http://www.rpwoodwork.com/blog/?p=2189#comment-117981 Peter,

I really regret not being able to do the NWA. Next year, I hope.

Jeff,

Great. This setup is inexpensive and takes very little area.

Rob

]]> By: Jeff Branch https://www.rpwoodwork.com/blog/2013/03/14/sharpening-bench-part-2/#comment-117936 Sun, 17 Mar 2013 14:13:56 +0000 http://www.rpwoodwork.com/blog/?p=2189#comment-117936 Interesting – I have been thinking of dedicated shop space for sharpening. Thanks for sharing.

]]> By: Peter Oster https://www.rpwoodwork.com/blog/2013/03/14/sharpening-bench-part-2/#comment-117931 Sun, 17 Mar 2013 13:26:09 +0000 http://www.rpwoodwork.com/blog/?p=2189#comment-117931 Thanks for not just dropping out of sight during your recovery. I was really looking forward to your presentations next weekend (NWA Showcase). Even though our tastes differ I find your wisdom and insight inspiring. If one were to just begin at the start of your posts and practice what you cover, it would be a pretty good course for free! Hopefully NWA next year.

]]> By: Rob https://www.rpwoodwork.com/blog/2013/03/14/sharpening-bench-part-2/#comment-117481 Thu, 14 Mar 2013 14:31:01 +0000 http://www.rpwoodwork.com/blog/?p=2189#comment-117481 Hi Ralph,

No. Puddles, drips, and spray do not go through the poly, and, for whatever reason with this setup, don’t end up near the edge of the surfaces where water could seep into the seam. It would be best to seal the seam with clear siliconized caulk. However, I never got around to doing that and I haven’t had a problem.

Rob

]]> By: Ralph Boumenot https://www.rpwoodwork.com/blog/2013/03/14/sharpening-bench-part-2/#comment-117409 Thu, 14 Mar 2013 10:42:27 +0000 http://www.rpwoodwork.com/blog/?p=2189#comment-117409 Do you have any problems with capillary action allowing water to go underneath your poly?

]]>